Protocol Galileo Stealth Housing Replacement

Geschrieben von: Matthew Selting
  • Kommentare: 0
Protocol Galileo Stealth Housing Replacement

Schwierigkeitsgrad

Easy

Schritte

6

Zeitaufwand

5 Minuten

Einleitung

This guide will walk you through how to separate the upper and lower housing units of the drone. Minimal tooling is required; however, prerequisite steps are required. This guide is useful for accessing internal components of the drone.

  1. JZPVK5TU2XE1hqSm

    • Remove the chrome shaft cover by lightly pulling it away from the drone.

  2. YPZOKcJc6fiFnxk6

    • Using a Phillips #000 screwdriver, remove the 7mm screw from the propeller stop.

    • Be sure to apply adequate pressure when removing the screw to prevent stripping it out.

  3. bnqbeOxCleNFal1Z

    • Remove the propeller stop from shaft by lightly pulling it away from the drone.

  4. vPLYKDEG6geOScxF

    • Remove the propeller from shaft by lightly pulling it away from the drone.

  5. KgcLUybLL5moWkOU
    KgcLUybLL5moWkOU
    EsYAAqiGrF6abtX4

    • Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.

    • Take care to place the screws in a safe place to prevent losing them.

  6. 2FHwmL6J2PCZFOK4

    • Separate the upper and lower housing units by lightly pulling the two housing units apart.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Matthew Selting

Mitglied seit: 15/02/18

432 Reputation

0 Kommentare